Gecko [ www.ilwfwelfarefederation.com ]

Name	Size	Permission
targeted	[ DIR ]	drwxr-xr-x
.config_backup	1.27 KB	-rw-r--r--
config	1.23 KB	-rw-r--r--
semanage.conf	2.61 KB	-rw-r--r--

Code Editor : .config_backup

# This file controls the state of SELinux on the system.
# BACKUP_SELINUX= can take one of these three values:
#     enforcing - SELinux security policy is enforced.
#     permissive - SELinux prints warnings instead of enforcing.
#     disabled - No SELinux policy is loaded.
# See also:
# https://access.redhat.com/documentation/en-us/red_hat_enterprise_linux/9/html/using_selinux/changing-selinux-states-and-modes_using-selinux#changing-selinux-modes-at-boot-time_changing-selinux-states-and-modes
#
# NOTE: Up to RHEL 8 release included, BACKUP_SELINUX=disabled would also
# fully disable SELinux during boot. If you need a system with SELinux
# fully disabled instead of SELinux running with no policy loaded, you
# need to pass selinux=0 to the kernel command line. You can use grubby
# to persistently set the bootloader to boot with selinux=0:
#
#    grubby --update-kernel ALL --args selinux=0
#
# To revert back to SELinux enabled:
#
#    grubby --update-kernel ALL --remove-args selinux
#
BACKUP_SELINUX=disabled
# BACKUP_SELINUXTYPE= can take one of these three values:
#     targeted - Targeted processes are protected,
#     minimum - Modification of targeted policy. Only selected processes are protected.
#     mls - Multi Level Security protection.
BACKUP_SELINUXTYPE=targeted

${this.title}

Code Editor : .config_backup